Installation Instructions for Ford Powerstroke 6.4L Stealth Module (2008-2010)

Included With Purchase

(1x) Stealth Module
(1x) Wire Harness with Fuel Rail Sensor Connections
(1x) Selector Switch

 

Module

Module

 


Step by Step Instructions

Let your truck sit with the hood popped, doors shut and the key fob away from the vehicle for at least 20 minutes. It is important to keep the key fob away and the doors shut during the entire installation process. DO NOT bring the key fob near the vehicle or open any doors until AFTER the module is fully installed and connections are verified. This allows the computer to 'sleep' and for your engine compartment to cool down. Failure to do so will result in a check engine light on startup.

Step 1:

Locate the Fuel Pressure Sensor on the passenger side of the engine, near the flexible rubber boot of the intake tube going to the air filter.

Sensor Connections


Step 2:

Unplug the Fuel Pressure Sensor connector and plug the male end connector of the module harness into the sensor.

Sensor Connections


Step 3:

Connect the factory male connector in the female end of the module harness.

Sensor Connections


 Step 4:

Connect the switch into the small white port of the module harness.

 Step 5:

Double check that all connections have snapped together securely.

 Step 6:

Mount the module away from heat and moving parts.

Example: Passenger or driver side fender well.

Note: Trucks equipped with dual alternators will not be able to access the fuel pressure sensor plug needed to install the module easily.