Installation Instructions for Land Rover Discovery 5 3.0L Stealth Module (2017-2020)

Included With Purchase

(1x) Stealth Module
(1x) Wire Harness with Fuel Rail Sensor Connections
(1x) Selector Switch

 

Module

Module

 


Step by Step Instructions

Let your truck sit with the hood popped, doors shut and the key fob away from the vehicle for at least 20 minutes. It is important to keep the key fob away and the doors shut during the entire installation process. DO NOT bring the key fob near the vehicle or open any doors until AFTER the module is fully installed and connections are verified. This allows the computer to 'sleep' and for your engine compartment to cool down. Failure to do so will result in a check engine light on startup.

Step 1:

Open hood and remove plastic engine cover. The engine cover is sitting on top of the engine without any fasteners. Gently pull straight up on the cover and it will release.

Sensor Connections


Sensor Connections


Step 2:

Locate your engine's fuel pressure sensor on the passenger side of the engine. See figure 1 and 2. Please note the orientation of the factory plug. There is a push release tab on the sensor plug, do not attempt to force this tab if it doesn’t want to release. If there is difficulty releasing the sensor, push the sensor aft while simultaneously squeezing the release tab. Once you hear/feel the plug release keep squeezing the plug to remove.

Sensor Connections


Sensor Connections


 Step 3:

The Stealth Module installs in line with your factory engine harness to the fuel pressure sensor. Recalling the factory plug orientation, install the modules harness to the fuel pressure sensor. The plug will snap into place, give this plug a slight tug to insure it is seated fully. Continued...

See figure 3. The last plug connects to the vehicles harness. See figure 4. This plug will only correctly fit one direction and snap into place. Just like with the previous connections, gently try to separate these connectors to ensure proper seating.

 Step 4:

Locate the Stealth Module, main wiring harness, and switch harness for assembly. The large gray connector on the main harness will connect directly to the module. Be sure to push the plug in so that both release tabs are locked. Connect the selector switch harness to the main module harness via the two white plugs

 Step 5:

Store the Stealth Module away from the engines moving and exhaust related parts. The passenger side fender well near the firewall is a common area for installation. The switch can be ran into the cabin of the vehicle or left tied up under the hood on your desired setting for ease of removal prior to service.

 Step 6:

Reinstall Engine cover by aligning the two aft stand offs by pushing down on the cover, then the forward two standoffs. Double check all connections and that wiring is routed away from any engine critical areas. Close hood and enjoy.