Installation Instructions for Nissan Titan Cummins 5.0L Stealth Module (2016-2019)

Included With Purchase

(1x) Stealth Module
(1x) Wire Harness with Fuel Rail Sensor Connections
(1x) Selector Switch

 

Module

Module

 

Step by Step Instructions

Let your truck sit with the hood popped, doors shut and the key fob away from the vehicle for at least 20 minutes. It is important to keep the key fob away and the doors shut during the entire installation process. DO NOT bring the key fob near the vehicle or open any doors until AFTER the  module is fully installed and connections are verified. This allows the computer to 'sleep' and for your engine compartment to cool down. Failure to do so will result in a check engine light on startup.

Step 1:

The module attaches to the fuel rail pressure sensor located on the right side of the engine beneath the EGR cooler.

Sensor Connections

Step 2:

Loosen the two 8MM bolts on the fuel line support beneath the EGR cooler. Slide the bracket toward the rear of the engine. The pressure sensor connector is now more accessible.

Sensor Connections

Step 3:

Disconnect the factory plug from the fuel pressure sensor. Plug the module harness plug into the sensor. Make sure the latch side of the plug is toward the ramp tab of the sensor. Plug the factory plug into the module harness receptacle. Again, make sure the latch side of the plug is toward the ramp side of the receptacle.

Sensor Connections


Sensor Connections

 Step 4:

Route the module harness toward the right fender well. Plug the module harness into the module. Secure the module using zip ties provided or with velcro to the top of the fuse box at the right fender well.

 Step 5:

Plug the switch harness into the module harness. Route the switch harness into the cab of the truck to an accessible location.

 Step 6:

Installation complete.

Turn Dial Clockwise

Stock - Low - Medium - High


Low - Towing at or near the vehicles maximum legal tow rating and low traction situations.
*consult your owners manual for vehicle tow rates

Medium - Moderate towing, around the middle of your vehicles tow rating, and ideal for everyday driving situations.

High - Maximum performance. Ideal for empty highway cruising.

The switch must remain plugged into the Stealth Module to remain in the desired setting. Do not switch power levels with the engine running.

You will see the best results when the selector switch is left in one setting for as long as possible.

Check Engine Light or Hard start on Install?

The most common reason for a check engine light on install is due to the truck not being asleep. If the Stealth Module has already been removed, please start the installation process over while giving special attention to the instructions above step 1. If the Stealth Module is still installed, verify connections and disconnect the negative terminals on your battery for a hard reset. Events that will wake the truck up: Not letting it sit for 15 minutes, opening/closing the vehicle door, having the key near the truck during install.

The most common reason for a hard start on install is due to improver connection. Please verify that all connections are straight and pushed in all the way. Be sure the harness is pushed in tight to the Stealth Module as well.

If you are still having trouble, please give our 24/7 tech support a call at (888) 613-4304

Remove the Stealth Module Before Service

Before going in for service, please remove the Stealth Module so that the truck is back to stock. This allows the technician to have a fresh base line when performing any work.